RE: [ECOS] Can't connect properly (TCP/IP)

["EXTERNAL Gladis Olaf (Praktikant; CR/AEM)" <external dot Olaf dot Gladis at de dot bosch dot com>]

Thank you,

This is the output from the serial port, when i am starting the programm
normaly.

RedBoot> lo test.srec
Using default protocol (TFTP)
Entry point: 0x00100000, address range: 0x00100000-0x00163730
RedBoot> go
[cyg_net_init] Init: mbinit(0x00000000)
[cyg_net_init] Init: cyg_net_init_devs(0x00000000)
Init device 'fec_eth'
PHY0: Intel LXT971
Eth physical state: 0780
FEC eth0: 10Mb
[cyg_net_init] Init: loopattach(0x00000000)
[cyg_net_init] Init: ifinit(0x00000000)
[cyg_net_init] Init: domaininit(0x00000000)
[cyg_net_init] Init: cyg_net_add_domain(0x00162748)
New domain internet at 0x00000000
[cyg_net_init] Init: cyg_net_add_domain(0x0016221c)
New domain route at 0x00000000
[cyg_net_init] Init: call_route_init(0x00000000)
[cyg_net_init] Done
[eth_drv_ioctl] Warning: Driver can't set multi-cast mode
[eth_drv_ioctl] Warning: Driver can't set multi-cast mode
[eth_drv_ioctl] Warning: Driver can't set multi-cast mode
skTPI_Init: FPGA loaded with file /FPGA_Default.rbf
            VERSION: 0x101D and
$T04thread:00000006;40:001647c0;01:00164788;#41+

So the programm hang up before the previous message has been wirtten
completly, i dont think 
That i would get more information (??) when i add some diag_printf().
But i used a debugger (via tcp)
And the code will e executet until the connect statement, and then it
stops.

I also attached the capture from ethereal, and i think this looks quite
normal.

Node ---> PC   [Syn]
Pc   ---> Node [Syn,Ack]
Node ---> PC   [Ack]

Has anybody an idea?

Thank you in advance.

Olaf Gladis

-----Original Message-----
From: Andrew Lunn [mailto:andrew@lunn.ch] 
Sent: Mittwoch, 31. Oktober 2007 17:03
To: EXTERNAL Gladis Olaf (Praktikant; CR/AEM)
Cc: ecos-discuss@ecos.sourceware.org
Subject: Re: [ECOS] Can't connect properly (TCP/IP)

>I would add some diag_printf() so you know what has been executed and
>if there are any errors returned.
>
>I would also use tcpdump/ethereal etc, to watch the packets flowing
>backwards and forwards. You should be able to see this data in a
>packet etc.
>
>       Andrew

Attachment: connect_01.cap
Description: connect_01.cap

-- 
Before posting, please read the FAQ: http://ecos.sourceware.org/fom/ecos
and search the list archive: http://ecos.sourceware.org/ml/ecos-discuss